The Hole Parameters that are shown will depend upon the Spacing option you have set on the Relative Distance page of this form.
|
Parameters |
Description |
|---|---|
| Drill Parameters |
Enter the Diameter of the hole in millimetres. The angle of the hole cannot be edited. The Hole angle is calculated using the spacing algorithm you have specified. |
| Pivot Point | The position of the pivot point cannot be edited. The Pivot point is either the point you have selected in the display, or for a parallel hole, is calculated from the pivot point of the related hole. |
| Charge Details | Enter attributes for Charge Type and Density. |
Finally, click OK to generate the new hole.
See Also